Forums » News and Announcements

Vaping with the VooPoo Drag 2 Starter Kit

    • 2108 posts
    March 23, 2019 3:42 AM EDT
    Inside the kit you receive two coils: The UForce U2 and the UForce N3
    Mesh. The U2 is a 0.4-ohm coil for 40-80W, while the N3 Mesh is for use
    between 65-100W.



    I tried the U2 coil first with Wild Berry Limeade by Doctor Big Vape Wholesale.
    At 60W, this coil is at its best, but I tried it at every wattage in
    the suggested range and still got great flavor. The hits from this coil
    are so smooth, and while the clouds aren’t the main attraction, they are
    decent, too.



    The N3 Mesh coil was equally as good, especially if you like vaping
    at higher wattages. The flavor was even better than the flavor from the
    U2, and the vapor production was greater. The coil lifespan was about a
    week and a half for the U2, but the N3 coil is still going strong after
    almost two weeks.

    I didn’t expect VooPoo to fail in the TC department and I was right. To
    test the Drag 2’s TC modes, I vaped a few custom coils and the flavor
    and vapor production was damn good. Ni, Ti, SS, whatever. If you’re coil
    material is good, you’ll experience a nice vape with the TC settings. I
    didn’t notice any lagging; in fact that GENE FIT chipset is so
    responsive it fires right up and switching through vaping modes with
    ease.



    The FIT modes on this mod are a nice option. I’m not sure how many
    people will use them, but I tried them out and they’re worth a shot. The
    battery mode did seem to give me a longer battery life, while the
    flavor and cloud modes helped to optimize my